IPricot IPR-S1000 - Manual (Page 82)

Configuring the IPR-S1000
77
abort
Allows to abort modifications after one or many set command.
auth (Authentication)
Allows to change the authentication level, i.e to switch to the public,
read or write level. A password is needed only when switching to a
more restricted level.
read: Allows to read the whole IPR-S1000 set up. The user cannot configure the
IPR-S1000.
write: Allows a complete configuration access, and allows to change the set up
parameters.
bye
Allows to exit the shell.
default + name of the profile that will become the starting profile
Allows to make a profile the startup profile.
defaultfactory
Allows to make the factory profile the startup profile.
delete + name of the profile to be removed
Allows to remove a profile.
dvb (Digital Video Broadcast)
Real-time access to the DVB interface.
dlevel: Digital level in percent.
fec: Current FEC, useful if FEC auto is enabled.
lock: Yes if locked, No otherwise.
macaddress: MAC address of this interface (it cannot be modified).
macaddresses: List of all MAC addresses currently treated by the receiver
card.
mpebytes: Amount of bytes received at MPE level on the satellite interface.
mpepackets: Amount of IP packets received through MPE on the satellite
interface.
sn: Eb/No. Signal noise ratio in dB.
temp: The temperature (given in celcius degree) of the warmest point to be
found in the equipment.
uncor.: Total number of packets that could not be corrected by the
demodulator.
vber: Rate of erroneous bits before Read Salomon (for example, a VBER of
1.7E-4> indicates that 1.7 bits are erroneous every 10000 bits).
dvbdump
Table dump.