IPricot IPR-S1000 - Manual (Page 29)

Configuring the IPR-S1000
24
4) With the «+» or «-» key, set the IP address.
5) Confirm the selection by pressing the «down» arrow.
14. Profiles
Note: # is always followed by a profile name. * indicates that the
profile is the startup profile.
141. Save
This screen allows you to save the current configuration under a new
profile name.
1) In the «1. Set config» menu, select «14. Profiles».
2) Enter that menu by pressing the «right» arrow.
3) Select «141. Save», and enter that menu by pressing the «right»
arrow.
Example:
4) With the «+» or «-» key, enter the profile name.
5) Confirm the value by pressing the «down» arrow.
142. Fact profile
This screen allows you to load the factory profile or to set it as the
startup profile.
1) In the «1. Set config» menu, select «14. Profiles».
2) Enter that menu by pressing the «right» arrow.
3) Select «142. Fact profile», and enter that menu by pressing the
«right» arrow.
Example:
IP address:
192.168.043.048/24
Profiles
141. Save
142. Fact. profile
143. TFTP load
144. TFTP save
Profile name:
_ _ _ _ _ _ _ _ _ _