IPricot IPR-S1000 - Manual (Page 86)

Configuring the IPR-S1000
81
kernelcontents: Displays the firmware contents.
kernelstate: Displays the amount of firmware present on the Flash Card.
kernelswap: Allows to switch from the current firmware to the previous one.
packages: Displays the list of installed packages (software) and their version
numbers.
reboot: Allows to restart the IPR-S1000.
tftpget: Allows to retrieve a kernel or a profile from the specified TFTP server.
tftpput: Allows to put a kernel or a profile on the specified TFTP server.
version: Displays two version numbers. The first one is the system version, and
the second one is the version of the satellite reception’s software.
tftpload
Loads the last profile downloaded by TFTP.
tftpsave
Makes the current profile ready to TFTP upload.
traceroute + IP address or «Host» name
Prints the route that packets take to reach network host.
numeric: Prints hop addresses numerically rather than symbolically and
numerically.
timeout: The process of traceroute will not exceed nsecond.
tos: Sets the type of service in probe packets to the following value (default
zero). The value must be a decimal integer in the range 0 to 255.
verbose: Verbose output. Received ICMP packets other than
TIME_EXCEEDED and UNREACHABLEs are listed.
wait: Sets the time (in seconds) to wait for a response to a probe (default 5
sec.).
tsdump
TS Dump is an MPEG2-TS (Transport Stream) monitoring tool. It can
perform the following tasks:
-Display the selected (by PIDs) TS packets in different ways (hexa,
hexdump style...).
-Record the selected TS packets into a file (using the browser or a FTP
server).
-Display statistics of the selected PIDs.
display_dump_date: If selected, tsdump will display the start and end dates at
the end of the dump.
display_pid_nbr: If selected, tsdump will display the PID number before each
TS packet.
diplay_pid_rate: If selected, tsdump will display each PIDs bit rate at the end
of the dump.
display_pkt_count: If selected, tsdump will display the number of TS packets
received for each PID at the end of the dump.