IPricot IPR-S1000 - Manual (Page 85)

Configuring the IPR-S1000
80
numeric: Allows to display IP addresses.
timeout: Lifetime of the request.
verbose: Allows to display all received ICMP packets.
ppp (Point to point protocol)
Acts on PPP process.
close: Allows to force, on request, the closing of the session.
isstarted: Allows to know if PPP service is launched. It launches out
automatically when a road borrows the PPP interface.
isup: Allows to know if PPP session is active. If active, allows to know
negotiated IP addresses.
pptp (point to point tuneling protocol)
Pptp module - VPN over PPTP.
close: Allows to force, on request, the closing of the session.
isstarted: Allows to know if PPTP service is launched. It launches out
automatically when a road borrows the PPTP interface.
isup: Allows to know if PPTP session is active. If active, allows to know
negotiated IP addresses.
quit
Allows to exit the shell.
rename + former_name new_name
Allows to rename a profile.
rm + name of the profile
Allows to remove a profile.
save
Allows to save the current profile.
set
Sets an attribute value.
spectrum
Spectrum analyser.
syslog
Displays system messages. To stop the flow, press CTRL C.
system
System action.
autoupdate: Allows to install or delete a new firmware received by the satellite
link.
date: Displays the current time and date.
kernelclean: Allows to delete the previous firmware.