IPricot IPR-S1000 - Manual (Page 25)

Configuring the IPR-S1000
20
131. Unicast
Unicast is communication between a single sender and a single
receiver over a network.
This screen allows you to configure the IPR-S1000 as a router
(Routing), a bridge (Bridging) or as a simple receiver.
1) In the «1. Set config» menu, select «13. IP».
2) Enter that menu by pressing the «right» arrow.
3) Select «131. Unicast», and enter that menu by pressing the «right»
arrow.
Example:
4) With the «+» or «-» key, select a mode.
5) Confirm the selection by pressing the «down» arrow.
132. Broadcast
A packet delivery system where a copy of a given packet is sent to all
hosts attached to the network.
This screen allows you to decide whether broadcast packets coming
from the satellite must be transmitted to the LAN or not.
1) In the «1. Set config» menu, select «13. IP».
2) Enter that menu by pressing the «right» arrow.
3) Select «132. Broadcast», and enter that menu by pressing the
«right» arrow.
Example:
4) With the «+» or «-» key, select «Yes» or «No».
5) Confirm the selection by pressing the «down» arrow.
133. Multicast
A special form of broadcast where copies of the packet are delivered to
only a subset of all possible destinations.
This screen allows you to select the IPR-S1000 as a multicast router
Unicast forwarding:
No
Routing
Bridging
Broadcast bridging:
No
Yes