Apollo 150 - Manual (Page 167)

User Manual version 2007
APOLLO 120/150 III
9-157
To install the software, insert the DOS and Windows Driver
Disk and type:
A:INSTALL <Enter>
or
B:INSTALL <Enter>
Respond to the on-screen prompts and instructions. You will
be asked to specify the model and configuration of your
controller, then select between DOS Express Installation,
Windows Express Installation, or Selective
Installation. The touchscreen controller of the
APOLLO 120/140/150 I is serial type. The model
number is E271-2210 AccuTouch. Baud rate of the
controller is “9600”. The APOLLO 120/140/150 I uses
onboard COM3 to drive this controller, IRQ is selected
by BIOS setting. IRQ10 is the factory default setting
for COM3. The software to be installed and disk space
requirements will be displayed for each installation option.
You may specify the drive and directory for the files you
choose to install, or use the default (C:\TOUCH).
The INSTALL program will modify your AUTOEXEC.BAT file,
(and SYSTEM.INI file for Windows installations). Copies of
the original files will be saved as AUTOEXEC.OLD and
SYSTEM.OLD.
Command Line Flags
Several flags may be specified on the INSTALL command line.
To override the default system language used by INSTALL,
specify the -L flag as follows:
INSTALL -L <x>
Use -Lg or -Ld for German, -Ls for Spanish, -Lf for French, or
-Le for English.
To override the path to C:\AUTOEXEC.BAT, use the -a flag as
follows:
INSTALL -a <filename with path>