Apollo 150 - Manual (Page 84)

User Manual version 2207
APOLLO 120/150 III 5-74
To assemble the stand module (Fig. 5-14 (1)) to the main
system (2), simply tighten the two units together with 4
screws from the base. Then, install the two base back covers
(4 & 5) to the unit as shown below. There is an additional
knob in the accessory. If touchscreen is to be used with the
system, it is suggested that the additional knob is to be
assembled to the system to prevent the system from
wobbling. By swiveling the knob and pulling the base up and
down, the angle can be fixed at 45 to 90
0 .
°ò ®y²Õ «~
¥D Åé »P °ò ®y²Х ¥Я
¥D Ей ²Х «~
APOLLO 120/150 ©³ ®y-× ¹¢ ¤W »\
APOLLO 120/150 ©³ ®y-× ¹¢ ¤U »\
F
IGURE
5-14: APOLLO
STAND TO MAIN SYSTEM ASSEMBLY