Apollo 150 - Manual (Page 72)

User Manual version 2207
APOLLO 120/150 III 5-62
5.8. LCD Module Assembly
Figure 5-8 and 5-9 illustrate the way to assemble the
APOLLO’s LCD module.
The LCD does not fix to the main system directly. Rather, it is
to be fixed to a LCD holder, then to the main system. The
assembly of APOLLO 120 LCD module slightly differs from
that of APOLLO 150.
1. For APOLLO 120, there are two LCD brackets (Fig. 5-8 (2)
& (3)) used to fix to the LCD panel to the LCD holder (11)
from the up & down sides. Fix the two brackets to the
LCD holder first.
2. Fix the LCD panel to the LCD holder with four 3*8
screws.
3. Attach the insulator to the invertor.
4. The invertor cable for APOLLO 120 is a 4-pin to 4-pin
cable and for APOLLO 150 is a 4-pin to 7-pin cable with
wafer connectors at both sides. Connect the one end of
the invertor cable to invertor first. The other end is for
later connection to the onboard INV1.
5. Connect the pink-white high voltage wires from the LCD
the invertor.
6. The invertor for (Fig. 5-8 (9)) APOLLO 120 is to be fixed
at the right middle side of the LCD holder with the up
side down and for APOLLO 150 (Fig. 5-8 (7)) is at the
reverse side of the LCD holder later after the LCD
module is to be installed to the system..
There are other accessories to be put on the LCD module.
1. Fix 6 bronze sticks (15 mm) to the lower sides of the LCD
holder. Fix the IR/LED board to the LCD holder with two
3*6 screws.
2. The two speakers (Fig. 5-8 (6)) are to be fixed to the right
and left sides of the IR/LED board. The speaker wires are
to be connect to the 2-pin header on the IR/LED board.