Apollo 150 - Manual (Page 82)

User Manual version 2207
APOLLO 120/150 III 5-72
ЕK ¥у «б »\
APOLLO ЕK ¥у «б »\²Х «~
I/O »\
MODULE APOLLO IO A1.0
SCSI 68P-SCSI 68P L:180mm
F
IGURE
5-12: APOLLO
BACK MODULE ASSEMBLY
5.12. Back Panel Assembly
The back panel module is the last module to be integrated to
the APOLLO main system before the plastic housing is to be
installed to the system.
1. On the I/O board, there are 6 D-SUB connectors with 2
bronze sticks on each side. Remove the 12 bronze sticks.
2. Insert the I/O board to the I/O bracket (2) and fix them
together with the 12 bronze sticks. Fix them again with
2 screws on the other side.
3. Fix the complete I/O module to the metal back panel (1)
five flat-head 3*5 screws.
4. Connect one end of the 2 68-pin SCSI cables (Fig. 5-12
(4)) to the I/O board (3). Via the 2 SCSI cables, all the
onboard I/O signals are converted to the I/O board for
device cable connection.
5. Connect the other end of the two SCSI cables to the SCSI
1 and SCSI 2 connectors on the motherboard.
6. Fix the back panel module to the main system.
7. Fix a stand bracket at the bottom side of the chassis with
2 screws.