American Dryer Corp. Phase 6 Microprocessor Controls ML-190HS - Manual (Page 18)

14
M. MANUAL RESET THERMOSTAT
This is located inside the dryer in the lint compartment
above the lint drawer. This thermostat senses the
heated air after it has passed through the tumbler
(basket). If the air temperature gets too hot, the
thermostat will shut off the burner. Tumbler (basket)
and blower will run, but dryer will not heat until this
thermostat is manually reset.
N. LINT DRAWER
The lint drawer is a pullout type and is located
at the bottom of the dryer in the lint
compartment. Simply grab the lint drawer
handle, slide out the drawer, brush off the lint,
and slide the drawer back in. The lint screen
must be kept clean in order for the dryer to
operate properly and efficiently.
O. LINT DRAWER SWITCH
The lint drawer switch is located in the lint
compartment and attached to the side of the
lint drawer track. The lint drawer switch
insures that the dryer will operate only when
the lint drawer is completely closed. This is a
safety device and should never be disabled.