American Dryer Corp. Phase 6 Microprocessor Controls ML-190HS - Manual (Page 45)

41
SECTION VII
ELECTRICAL TROUBLESHOOTING
The information provided will help isolate the most probable components associated with the difficulty described.
The experienced technician realizes, however, that a loose connection or broken or shorted wire may be at fault
where electrical components are concerned...not necessarily the suspect component itself.
ELECTRICAL PARTS SHOULD ALWAYS BE CHECKED FOR FAILURE BEFORE BEING
RETURNED TO THE FACTORY.
The information provided should not be misconstrued as a device for use by an untrained person in making
repairs. Only properly licensed technicians should service the equipment.
OBSERVE ALL SAFETY PRECAUTIONS DISPLAYED ON THE EQUIPMENT or SPECIFIED IN
THIS MANUAL WHILE MAKING REPAIRS.