Merrychef 402s - Manual (Page 5)

5
For all cord connected appliances:
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord
having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly
installed and grounded.
WARNING — Improper use of the grounding can result in the risk of electric shock.
Consult a qualified electrician or Serviceman if the grounding instructions are not completely understood
or if doubt exists as to whether the appliance is properly grounded.
Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or
serviceman install an outlet near the appliance.
For a permanently connected appliance:
GROUNDING INSTRUCTIONS
This appliance must be connected to a grounded, metallic, permanent wiring system, or an equipment
grounding conductor should be run with the circuit conductors and connected to the equipment grounding
terminal or lead on the appliance.
ELECTRICAL INSTALLATION
In case of Radio or Television Interference
This equipment generates and uses radio frequency energy and if not installed and
operated correctly, in strict accordance with the manufacturer’s instructions, may cause
harmful interference to authorized radio communication services.
It has been type tested and found to comply with the limits for Part 18.307 conducted emissions for
consumer equipment and Part 18.305 radiated emissions, which are designed to provide reasonable
protection against such interference. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures:
1) Re-orientate the receiving antenna.
2) Relocate the microwave with respect to the receiver.
3) Plug the microwave into a different outlet so that the receiver and microwave are on different branch
circuits.
If necessary the user should consult the dealer or an experienced radio/television technician for additional
suggestions.
Note: Modifications should only be carried out by the manufacturer or authorized representative to ensure
continuing conformance.
This device complies with Part 18 of the FCC rules .
POWER SUPPLY: CIRCUIT BREAKERS
If the oven is connected to a ground fault detection device, it is required that the GFP or GFEP will allow a
minimum of 30 milliamps ground current without interrupting the circuit.