Antunes, AJ Series 9100100 - Manual (Page 15)

DELUXE FOOD WARMER
14 P/N 1010678 Rev. F 09/04
DELUXE FOOD WARMER
15 P/N 1010678 Rev. F 09/04
OPERATION (continued)
Fault Codes
When the programming parameters for Minutes/
Seconds/SHO/H2O have been inadvertently changed
to a setting below or above their limits, the unit displays
the “ ERR” fault code. If this code appears, you must
clear these settings using the following procedure:
1. Turn the Rocker Switch (power On/Off) to OFF.
2. Press and hold the Program and the Start/Stop
buttons simultaneously.
3. Turn the unit on while holding the buttons.
Release the buttons when the unit stops beeping.
NOTE: Repeat Steps 1 through 4 if the unit still dis-
plays the “ERR” fault code.
4. The display will now register 15:00.
NOTE: It is recommended that the SHO and H2O
settings be adjusted to the recommended settings
shown in the Programming section of this manual.
MAINTENANCE
WARNING
Turn the unit off, disconnect the power source
and allow the unit to cool down before performing
any service or maintenance on the unit.