Myron L PS6FCE - Manual (Page 19)

14 15
D. Procedure to Select a Solution
NOTE: Check display to see if solution displayed (KCl, NaCl, 442) is
already the type desired. If not:
1. Press ,
MIN
SALT
or to select the parameter on
which you wish to change the
solution type.
2. Press and hold key
for 3 seconds to make
“SEL” appear (see Figure 3).
(For demonstration purposes,
all 3 solution types are shown simultaneously.)
3. Use the or key to select type of solution desired
(ref. Solution Characteristics, pg. 40). The selected solution
type will be displayed: KCl, NaCl, or 442.
4. Press to accept new solution type.
In these first six sections, you have learned
all you need to take accurate measurements.
The following sections contain calibration,
advanced operations and technical information.
F igure 3
K C l
442
NaC l