Comfort-Aire HKV300A - Manual (Page 46)

Installation, Operation & Maintenance HKV SERIES Heat Controller, LLC
45
Installer: Complete unit and system checkout and follow unit start-up procedures in the IOM. Use this form to record
unit information, temperatures and pressures during start-up. Keep this form for future reference.
Job Name: ________________________________ Street Address: _____________________________________
Model Number: ____________________________ Serial Number: ______________________________________
Unit Location in Building: _______________________________________________________________________
Date: ________________________________ Sales Order No: __________________________________________
In order to minimize troubleshooting and costly system failures, complete the following checks and data entries before
the system is put into full operation.
Temperatures: F C
Pressures: PSIG kPa
Cooling Mode Heating Mode
Entering Fluid Temperature
Leaving Fluid Temperature
Temperature Differential
Return-Air Temperature
DB WB DB WB
Supply-Air Temperature DB WB DB WB
Temperature Differential
Water Coil Heat Exchanger
(Water Pressure IN)
Water Coil Heat Exchanger
(Water Pressure OUT)
Pressure Differential
Compressor
Amps
Volts
Discharge Line Temperature
(After 5 Minutes)
Motor
Amps
Volts
Do not connect gage lines
Start-up Sheet Log