RMS Technologies R325P DRIVER User Manual
Page 12
Advertising
Communicating with the R325PE
Step 1: Move all dipswitches to the OFF position. Place jumper on Pins 1 & 2.
Inage 6.3
1. Connect P1 to PC via RS485-232 Converter Card or USB485 Converter Card.
2. Set up HyperTerminal by selecting correct COM port
3. Settings for HyperTerminal is as follows: 57600, 8 bits, None, 1, None
4. The R325P Driver only version allows for changing the hold timeout settings, the amount of mixed
decay, and to check the firmware revision level.
RS485-232 Converter Card
Figure 6.2
Move ALL
dipswitches
to the OFF
Position
Jumper is
placed
closest to
the LED.
RMS Technologies
Page 12
Version 1.01
R325PE Single Axis Closed loop Driver/Indexer Manual
5/29/2013
Advertising