EZ Dupe Multi-Format 1 Copy Duplicator - Manual (Page 35)

II. Function Introduction
•
Eject Target Only: Only eject target trays with disc inside once the
system is booted up.
•
Eject Source Only: Only eject source disc once the system is
booted up.
•
Eject All Trays: To eject all trays once the system is booted up.
8-5. Reader Speed
This setting allows you to adjust the reading speed of source drive. The
default setting of reader speed of BD is 4X, DVD is 24X and CD is 40 X.
8-6. Compare Speed
The reading speed of drives and discs is what affects the quality of
duplicated discs. This setting allows you to adjust the reading speed of
target drives to match up the reading speed of discs. The default setting
of BD’s compare speed is 4X, DVD is 8X and CD is 40X.
8-7. Language
You can set a desired language for duplicator menus and functions.
8-8. Clear Setup
This setting will reset all functions back to the manufacturer’s default settings.
8-9. Advanced Setup
•
Power On Time: You can set a warm-up time from 5 to 99
seconds to warm up the duplicator when it is turned on. The
default setting is 10 seconds.
•
Start-up Menu: You can select which function you would like to
show up when the duplication is turned on.
•
Skip Read Error: You can set this function to enable skipping disc
errors in order to avoid bad quality copies. If you are confident that
your source disc has only small or insignificant errors due to
physical damages and can be overlooked, you can select NO to
disable this function.
35