Data protection, Tape in use – ADIC DS9000 Series User Manual
Page 39
Operation and Maintenance
27
Data Protection
Write-Protection of the Data Cartridge While Inside the Drive
The Write-Protect switch on the data cartridge can be moved while the
cartridge is loaded into the drive. The drive will turn on the Write Protected
LED immediately. However, if the drive is writing to the tape, write protect
does not take effect until the write operation is completed.
S
If you move the Write-Protect switch from the write-protected position
(on the left) to the write-enabled position (to the right), the tape becomes
write-enabled after several seconds.
S
If you move the Write-Protect switch from the write-enabled position
(on the right) to the write-protected position (to the left), the tape becomes
write-protected after several seconds.
Write-Protection of the Data Cartridge Outside of the Drive
Move the Write-Protect switch to the left to write-protect the tape. The
Write Protect LED (orange) is ON and data cannot be written to, or erased
from the tape.
Move the Write-Protect switch to the right to make the tape write-enabled.
Data can now be written to, or erased from the tape, assuming it is not already
software write-protected.
Tape in Use
Whenever the Tape in Use LED (yellow) is ON steady, the tape is ready to use. When the tape is being read,
written, or rewound, the Tape in Use LED blinks.
Use the following table to determine what is happening during cartridge use:
(Right Indicator Panel)
LED State
Meaning
Tape in Use
ON steady
Blinks irregularly
Blinks regularly
A cartridge is loaded, but the tape is not moving. This
can mean no application is communicating with the
controller, or that the application is communicating but is
not delivering commands for tape motion.
A read or write is in progress.
Tape is loading, unloading, or rewinding.
Operate Handle ON and beeper sounds
Tape is unloaded into the cartridge and the cartridge can
now be removed, or if the drive is unloaded, a cartridge
can now be inserted.
All LEDs
Blinking
An error has occurred during operation.