ADIC DS9000 Series - Manual (Page 53)

Drive Configuration 41
DLT7000/DLT8000 Drives
If the host computer system does not generate SCSI bus parity, disable the parity checking procedure in the
DLT7000/DLT8000 drive by installing a jumper over two pins on the DFDT connector. See Figure 11 for location
of the connector.
F ro n t
B e z e l
R ig h t S id e
TRM PWR Connector
DFDT Connector
Figure 11. DLT7000/DLT8000 Tape Drive Connectors (right side)
Figure 12 shows which pins of the DFDT connector have to be connected by jumper cables in order to disable parity.
Disable
Parity
Figure 12. Disable Parity Pins on DFDT Connector