ADIC DS9000 Series - Manual (Page 5)

v
Regulatory Notices
FCC Notices (USA Only)
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the manufacturer’s instruction manual, may cause interference with radio and television reception. This
equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference with radio or television reception, which can be determined by turning
the equipment off and on, you are encouraged to try to correct the interference by one or more of the following
measures:
Reorient the receiving antenna.
Relocate the equipment with respect to the receiver.
Move the equipment away from the receiver.
Plug the equipment into a different outlet so that the equipment and the receiver are on different branch circuits.
If necessary, consult a representative of ADIC or an experienced radio/television technician for additional
suggestions. You may find the following booklet helpful: FCC Interference Handbook, 1996, available from the U.S.
Government Printing Office, Washington, DC 20402, Stock No. 004-000-00450-7.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
A Notice About Shielded Cables: Use only shielded cables for connecting peripherals to this device
to reduce the possibility of interference with radio and television reception. Using shielded cables
ensures that you maintain the appropriate FCC radio frequency emissions compliance (for a Class A
device) or FCC certification (for a Class B device) of this product.
The following information is provided on the device or devices covered in this document in compliance with FCC
regulations:
Product Name: DS9000 Series
Model number: DS9X00
Company name: Advanced Digital Information Corporation
PO Box 97057
Redmond, WA 98073-9757 USA
(425) 881-8004