Kramer Electronics VP-725NA - Manual (Page 34)

VP-725NA - Configuring and Controlling the VP-725NA 29
7 Configuring and Controlling the VP-725NA
This section describes how to configure and control the VP-725NA via the:
• OSD menu (see Section 7.1 )
• LCD display (see Section 7.2 )
• Infrared remote control transmitter (see Section 7.4 )
You can also control the VP-725NA via the Ethernet (see Section 7.3 )
7.1 Configuring the VP-725NA via the OSD MENU Screens
The OSD superimposes a menu on the screen from which you can configure and
control each input signal on your
VP-725NA, using the MENU, ENTER, -, +, UP and
DOWN OSD buttons on the front panel and the remote transmitter.
To use the OSD menus:
1. Select the desired input signal.
2. Use the menu buttons as follows:
 To display the main MENU screen with eight interactive icons (see
Figure 13 ), press the MENU button on the front panel or the MENU key
on the infrared remote control transmitter (see Section 7.3 )
Each icon represents a Level 1 function. In addition to Level 1, the OSD structure
includes Level 2 (a subset of level 1), Level 3 (a subset of level 2) and a
numerical range.
 To move to the previous level in the OSD screen (Esc), press the MENU
button on the front panel or the MENU key on the infrared remote
control transmitter
 To select menu icons, press the + and – buttons and then press ENTER
 To increase and decrease the (numerical) rate, use + and – buttons
respectively
Figure 13: MENU Items