Kramer Electronics VP-725NA - Manual (Page 44)

VP-725NA - Configuring and Controlling the VP-725NA 39
7.1.5 The Setup Screen
Figure 21 defines the Setup screen.
Figure 21: Setup Screen
Setup Screen
Setting
Function Default
Save Save a profile: From Profile 1 to Profile 8
Recall Recall a profile: From Profile 1 to Profile 8
Slideshow Set speed for slide show (see Section 7.1.6 ): Min, Low, Mid, Long,
Max, Off
Off
Frame Lock Locks the vertical refresh rate of the output to that of the input:
On/Off
Note that seamless switching is not possible when working in the Frame
Lock mode unless all sources are frame synchronized.
In cases where the output resolution can support the vertical refresh rate
of the input, the output refresh rate changes according to the input
refresh rate
Off
Auto Image Automatically adjust and align the picture each time one of the
UXGA inputs is selected or if the UXGA input resolution has
changed: Manual, Auto
Manual
Switching
Mode
Select seamless switching (fade-through-Black) or fast switching
which is faster but may cause glitches on the output (applies only
when switching between analog inputs): Seamless, Fast
Seamle
ss
Factory Reset Reset your VP-725NA to its preset default settings: Confirm, Yes,
No
Advanced
Setup
Open the advanced setups (see Figure 22 ): Mode Set, OSD, Misc.,
Input, Output (see Section 7.1.7 )
EDID
EEPROM
Protect
EDID writing protection: On/Off
When an EDID file update is required, set the EDID protection to OFF