SIRIUS XDRC2UG - Manual (Page 32)

32
• Sedan/Coupe With the Antenna Placed at the Rear of the Roof:
1 . Feed the antenna cable from the antenna underneath the rubber
molding around the rear window . Use a blunt plastic putty knife or
similar blunt tool to lift the rubber molding around the rear window
and tuck the antenna cable underneath the molding . Route the
antenna cable around and down the window to the lowest point . If
your rear window does not have rubber molding, we recommend
consulting a professional installer .
2 . Route the antenna cable out of the window molding and into the
rubber weather stripping around the trunk opening . Lift the weather
stripping from the opening and tuck the cable inside it, then replace
the weather stripping . To avoid sharp bends in the cable, run the cable
inside the weather stripping for a few inches, then remove the cable
from the weather stripping inside the trunk . Keep the cable away
from hinges, gears, etc ., that could damage it .
3 . Route the cable out
from the rubber weather
stripping and along the
trunk wall . Continue routing
the cable into the vehicle
cabin through a conduit
or along an existing wiring
harness .
4 . Route the cable through
the main cabin area under
the interior trim, towards
Vehicle Installation