Atlantis DISKMASTER NAS65020 - Manual (Page 15)

15
1.7 Default Settings
The TCP/IP protocol stack and Ethernet network adapter must be installed. If not,
please refer to MS Windows relative manuals.
Before you configure this device you need to know the following default settings:
 Username: sysadmin
 Password: atlantis
 IP address: by DHCP, (If a DHCP server isn’t available in the network,
the DiskMaster will use 192.168.1.251 and Subnet Mask
255.255.255.0).
 Server name: DiskMasterG502D
DiskMaster saves all settings on formatted Hard Disk. If this
isn’t present all settings will be lost when DiskMaster is turn off.
1.8 HDD installation Guide
Following is a quick installation guide to get you up and running. For further details
on each of the settings, please refer to manual on CD.

Unscrew the 4 screws which screws the platic part on the HDD tray.
 Fit the HDD into the tray and screw the 4 screws which are unscrewed form
step 1.
 Slide the tray into DiskMaster metal frame.
 Push the tray into metal frame firmly and lock the handle of the try.
 First you must connect the product to the RJ45 ports the PCs of your Lan or
others Switch. In the end connect the DC Adapter to the socket then to the
DiskMaster.
 Once you’ve done all the connections the product will carry on immediately a
autotest (180 seconds). With the power source on, once the device is
connected, the Power and LAN port LEDs will light up indicating a normal
status.
Please check the following pictures.