Atlantis DISKMASTER NAS65020 - Manual (Page 21)

21
RAID Mode
You need to install 2 HDDs to create RAID system on DiskMaster. When you first
time login DiskMaster or System Disk hasn’t been created, you will be asking if you
would like to do RAID configuration.
Tap OK button on last dialogue box, the screen will display raid type selection as
the picture below (or System ->Hard disk Management -> Hard Disk
Configuration).
Choose a proper RAID type you want to create on DiskMaster.

RAID 0: Total capacity will be 2 times of the smaller HDD.
 RAID 1: Total capacity will be the same to the smaller HDD.
After RAID 0 or RAID 1 is selected, click Save to create RAID system. Before
creating RAID system, 2 HDDs must be totally clean, there can’t be any partitions
exist on the HDD.
When RAID system has been created successfully, message will pop as the picture
above. Click Format to start creating DiskMaster system.
Disk formatting is a critical operation of DiskMaster, please aware the notice the
message shown as the popup dialogue box. Click OK to start disk formatting.
Disk formatting procedure includes 3 steps: Disk Partition, Disk Formatting and
System Build up. It will take longer time to complete the procedure as the disk
capacity getting larger. Please be patient to wait for its completion.
When formatting completed, the system disk of DiskMaster has been established
also, and the message on the screen will be: