AT&T CL82351 - Manual (Page 52)

Answering system
46
Answering system settings
Call screening
Use this feature to choose whether incoming messages can be heard over
the telephone base speaker when they are being recorded. If you turn call
screening on, you hear the incoming message. While monitoring an incoming
message, you can answer the call by pressing
PHONE/
FLASH
or /SPEA�ER SPEA�ER
on the handset.
To change the setting:
1. When the handset is in idle mode, press
MENU/
SELECT
to
enter the main menu.
2. Press q
CID
or p
DIR
to scroll to >Answering sys, then
press
MENU
/SELECT.
3. Press q
CID
or p
DIR
to scroll to >Ans sys setup, then
press
MENU
/SELECT.
4. Press
MENU
/SELECT to select >Call screening.
5. Press q
CID
or p
DIR
to choose >On or >Off.
6. Press
MENU
/SELECT to save the setting. You hear a
confirmation tone. Press
OFF/
CANCEL to cancel.
NOTE: For more information on call screening, see page 50.
Number of rings
You can set the answering system to answer an incoming call
after 2, 3, 4, 5, or 6 rings. You can also select toll saver, which
is explained below. Unless you change it, the answering system
answers an incoming call after 4 rings.
To set the number of rings:
1. When the handset is in idle mode, press
MENU/
SELECT
to
enter the main menu.
2. Press q
CID
or p
DIR
to scroll to >Answering sys, then press
MENU
/SELECT.
3. Press q
CID
or p
DIR
to scroll to >Ans sys setup, then press
MENU
/SELECT.
4. Press q
CID
or p
DIR
to scroll to ># of rings, then press
MENU
/SELECT.
Play messages
>Answering sys
p
q
Answer ON/OFF
>Ans sys setup
p
q
> Call screening
# of rings
p
q
CALL SCREENING
>On
p
q
Call screening
># of rings
p
q
# OF RINGS
>4
p
q