AT&T CL82351 - Manual (Page 64)

58
Adding and registering handsets
Your telephone can support up to 12 cordless handsets
(AT&T model CL80101, sold separately). The handset must
be registered to the telephone
base before use. You must
register each handset separately.
The handsets provided within your product box are already registered as
HANDSET 1 and so forth. Additional handsets are assigned numbers in the
sequential order they are registered (up to
HANDSET 12).
Register a handset to your telephone base
1. Make sure the handset is out of the telephone base or
charger and shows Put HS on BASE to register before you
begin registration.
2. Put the handset you wish to register on the telephone
base cradle.
3. The screen shows Registering... Please wait and the
IN USE light turns on. It takes up to 90 seconds to
complete registration. Then
HANDSET X Registered
appears on the screen, with HANDSET being the handset
name and X being the handset number (1-12). The
handset beeps and the IN USE light turns off. The
handset is now registered with the telephone base.
If registration fails, the system will automatically try
to register again. If registration fails after the third try,
Registration failed appears on the screen for a few
seconds, and then
Put HS on BASE to register. This may
take up to 5 minutes to occur. Please start again from
Step 1 above.
Put HS on BASE
to register
Registering...
Please wait
HANDSET X
Registered
Appendix
For registration, put
the handset on the
telephone base, not
the handset charger.