Lenovo ThinkServer RD340 User Manual
Page 36
On each hot-swap redundant power supply, there is a status LED near the power cord connector. When the
LED is lit in green, it indicates that the hot-swap redundant power supply is working correctly. When the LED
is lit in amber, it indicates that the hot-swap redundant power supply is likely to fail or has failed.
3
Low-profile PCI Express card slot
It is recommended that you attach a RAID card to the low-profile PCI Express card slot.
Physical link width
Negotiable link width
Supported card length and height
x8
x4, x2, x1
Low-profile card
Note: If a ThinkServer HBA is available, refer to its user guide for detailed information. The user guide is
available for download at:
4
PCI Express card slot
Used to attach an Ethernet card or any other supported PCI Express card.
Physical link width
Negotiable link width
Supported card length and height
x16
x16, x8, x4, x2, x1
Half-length, full-height card
Note: If a ThinkServer HBA is available, refer to its user guide for detailed information. The user guide is
available for download at:
5 8 9
Ethernet connectors (RJ-45)
Used to attach an Ethernet cable for a LAN. Each Ethernet connector has two status LEDs to help you
identify the Ethernet connectivity, activity, and connection speed.
Note: The Ethernet connector 0 (callout
9
) marked with “MGMT” is for system management by default.
However, you also can set the Ethernet connector 1 or 2 for system management use in the Setup Utility
program. See “Setting the mode of the Ethernet connectors” on page 57.
Figure 14. Ethernet status LEDs
Ethernet status LED
Color
Status
Description
Amber
On
The connection speed is 1000 Mbps.
Green
On
The connection speed is 100 Mbps.
1
Left
None
Off
The connection speed is 10 Mbps.
Green
On
The server is connected to a LAN.
None
Off
The server is disconnected from a LAN.
2
Right
Green
Blinking
The LAN is connected and active.
24
ThinkServer RD340 User Guide and Hardware Maintenance Manual