Airlink101 AR580W3G - Manual (Page 103)

93
procedures, or click ‘Apply’ to reboot the router so the settings will take effect (Please
wait for about 30 seconds while router is rebooting).
3-3-1 Access Control
This function allows or denies computers with specific MAC address from connecting to
the network; it can also allow or deny computers with specific IP address, protocol, or
port.
Please click ‘Firewall’ menu on the left of web management interface, then click ‘Access
Control’, and the following message will be displayed on your web browser:
Here are descriptions of every setup items:
Enable MAC Check this box to enable MAC address based
Filtering (1): filtering, and please select ‘Deny’ or ‘Allow’ to decide the behavior
of MAC filtering table. If you select deny, all MAC addresses listed
in filtering table will be denied from connecting to the network; if
you select allow, only MAC addresses listed in filtering table will
be able to connect to the network, and rejecting all other network
devices.
1
2 3
5 6
7
8 9 10
12
13 14 15
16
11
4