Konica Minolta Magicolor 3300DN - Manual (Page 142)

Dual In-Line Memory Modules (DIMMs) 134
1
If you are not to the point when you are able to print an advanced status
page (with the control panel’s Print Status? button) yet, skip to step 2.
If you have previously installed your printer and have confirmed that it is
printing, print an advanced status page in case you need to restore any
current memory settings after the DIMM installation.
Installing DIMMs automatically restores memory defaults. If your
memory settings are specific to your environment, print an
advanced status page before installing DIMMs, so you can recover
the current memory settings.
2
Turn off the printer and disconnect the power cord and all interface
cables.
3
Remove the controller board from the printer.
Loosen two screws,
one on each end of
the I/O connector
panel, and, using the
tab on the lower side
of the connector
panel, pull the
controller board
from the printer.
4
Position the controller
board on a flat surface
so the controller
board lies flat and the
I/O connector panel is
facing you.
If you want to install more memory, you have to exchange one or
more DIMMs for DIMMs with a greater memory capacity.
IIIIIIII IIIIIIII IIIIIIII IIIIIIII IIIIIIII IIIIIII III IIIIIIII IIIIIIII IIIIIIII IIIIIIII II IIIIIII
IIIIIIII IIIIIIII IIIIIIII IIIIIIII IIIIIIII IIIIIII III IIIIIIII IIIIIIII IIIIIIII IIIIIIII II IIIIIII