Konica Minolta bizhub 25e - Manual (Page 106)

1
2
3
4
Machine management settings
Setting security 4-25
Setting Description Settings
MAC Address
List
*2
Enter the addresses to set as exceptions to the
basic policy selected in the settings.
• If you selected “Reject all specified address(es)
except for those listed below”, enter the MAC
addresses to allow.
• If you selected “Authorize all address(es) except
for those listed below”, enter the MAC addresses
to reject.
Up to 50 address can be registered.
Enter an address and click [Add] to add it to the
list.
• To delete an address entered in the list, select
its checkbox, and click [Delete].
• Click the same checkbox to deselect the item.
XX:XX:XX:XX:XX:XX
format (where XX is
0 to 9, A to F)
IP Address
Filtering
Setting *1 Check “Available setting” to enable this setting,
and select the basic policy for the access
restrictions. Reject all specified
address(es) except
for those listed below
Authorize all
address(es) except
for those listed below
IP Address List
(IPv4)
*2
Enter the IPv4 addresses (specified individually,
with a mask, or with a range) to set as exceptions
to the basic policy selected in the settings.
• If you selected “Reject all specified address(es)
except for those listed below”, enter the IPv4
addresses to allow.
• If you selected “Authorize all address(es) except
for those listed below”, enter the IPv4 addresses
to reject.
Enter an address and click [Add] to add it to the
list.
• To delete an address entered in the list, select
its checkbox, and click [Delete].
• Click the same checkbox to deselect the items.
XXX.XXX.XXX.XXX
format (Where XXX
is a number between
0 and 255.)
IP Address List
(IPv6)
*2
Enter the IPv6 addresses to set as exceptions to
the basic policy.
• If you selected “Reject all specified address(es)
except for those listed below”, enter the IPv6
addresses to allow.
• If you selected “Authorize all address(es) except
for those listed below”, enter the IPv6 addresses
to reject.
Enter an address and click [Add] to add it to the
list.
• To delete an address entered in the list, select
its checkbox, and click [Delete].
• Click the same checkbox to deselect the item.
XXXX:XXXX:XXX
X:XXXX:XXXX:X
XXX:XXXX:XXXX
format (Where XXXX
is a hexadecimal
number.)
*1 If at least one item is registered in the list, you cannot change the basic policy settings.
*2 Depending on the basic policy settings, the address entry item name and list title change. (For
example, if you selected “Allow all specified address(es)”, the address entry item changes to
“Rejected Address” and the list title changes to “Rejected Address list”.)