AB Soft ATX 12V - Manual (Page 43)

Hardware Installation SY- P4I865PE Plus DRAGON 2
38
Onboard LAN LED Definition
Step 5 Power On
You have now completed the hardware installation of your Motherboard
successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the system is
performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot up
sequence is completed. Then push the RESET button and press
<DEL> key again at the beginning of boot-up, during diagnostic
checks.
When this LED is lit, this
means the LAN is
running at 100 mbps, if it
is not lit, the Onboard
LAN is working at 10
mbps. This is the LAN activity
LED. It will blink when
it is active.