AB Soft ATX 12V - Manual (Page 55)

BIOS Setup Utility SY- P4I865PE Plus DRAGON 2
50
3-1.3 OnChip IDE Device
Caution: Change these settings only if you are already familiar
with the IDE settings.
The [OnChip IDE Device] option changes the settings of the 82801EB
(ICH5) IDE controller. These settings do not influence the HighPoint 372N
or Silicon Image Sil3112 controllers.
The following screen shows setup default settings.
Phoenix – Award BIOS CMOS Setup Utility
OnChip IDE Device
IDE 1,2 /SATA 1,2 IDE only
IDE HDD Block Mode Enabled
Item Help
IDE DMA transfer access Enabled
On-Chip Primary PCI IDE Enabled
IDE Primary Master PIO Auto
IDE Primary Slave PIO Auto
IDE Primary Master UDMA Auto
IDE Primary Slave UDMA Auto
On-Chip Secondary PCI IDE Enabled
IDE Secondary Master PIO Auto
IDE Secondary Slave PIO Auto
IDE Secondary Master UDMA Auto
IDE Secondary Slave UDMA Auto
*** On-Chip Serial ATA Setting ***
x On-Chip Serial ATA Disabled
x Serial ATA Port0 Mode Primary Master
x Serial ATA Port1 Mode Primary Slave
Menu Level 
[Disabled]: Disabled SATA
Controller.
[Auto]: Auto arrange by
BIOS.
[Combined Mode]: PATA
and SATA are combined.
Max. of 2 IDE drives in
each channel.
[Enhanced Mode]: Enable
both SATA and PATA. Max.
of 6 IDE drives are
supported.
[SATA Only]: SATA is
operating in legacy mode.
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7: Optimized Defaults
After you have complete the changes, press [Esc] and follow the
instructions on your screen to save your settings or exit without saving.