A&D WM:PD4000136 Ambulatory Blood Pressure Monitor - Manual (Page 23)

Page 21
Use of the cuff cover
Step 1 Pass the air hose through the slit.
Step 2 Place the cover on the cuff as shown. Link them using the three velcro strips.
Air hose
Slit for air hose
Left arm cuff
Air hose
Slit for air hose
Right arm cuff
Cuff cover
common use
Slit
Velcro
Velcro
Velcro
Slit
Velcro
Velcro
Velcro
Attaching the cuff and recorder
Caution
❏ The standard cuff that is included with the TM-2430 is a left arm cuff.
❏ If the cuff is not attached at the correct position, the recorder may not measure
the blood pressure correctly and an error may occur.
❏ The left cuff is for use on the left arm of about 20cm ~ 31cm. If you need a
different cuff, purchase a cuff of the proper size and arm position. Refer to
"Option and Accessories".
❏ Do not use, if the patient has dermatitis, etc.
Keep the cuff clean. Exchange the cuff cover for each patient. The cuff cover
may be used for both right or left.
Steps for attaching the cuff and recorder
Step 1 Make a circle where the end of the cuff is passed through the ring.
Step 2 Search for the brachialis artery using palpation.
Initializing the recorder Use of Cuff Cover