A&D WM:PD4000136 Ambulatory Blood Pressure Monitor - Manual (Page 26)

Page 24
Operation
Automatic Measurement
Caution
❏ Automatic measurement uses the internal clock and parameters of automatic
measurement. Refer to section "Parameters for the Display and Clock" and
"Selection for the automatic measurement" for setting these parameters.
❏ Press and hold the AUTO ON/OFF key for approx. 3 seconds so as to turn off " A " symbol
on display, when the patient stops the automatic measurement or detaches the cuff.
If the automatic measurement mode is running without a patient arm or resistance,
damage will occur to the cuff.
Starting or re-starting automatic measurement mode
Step 1 Confirm the parameters for automatic measurement. Refer to "Selection for
the automatic measurement".
Step 2 Press and hold the AUTO ON/OFF key for about 3 seconds. When the " A " is
displayed the recorder starts an automatic measurement based on the
internal clock and the parameters for automatic measurement.
Operation using mode II (Sleep mode)
Step 1 Press the AUTO ON/OFF key turning off the " S " when the patient wakes up.
Step 2 Press the AUTO ON/OFF key turning on the " S " when the patient goes to bed.
Stopping or canceling automatic measurement
Step 1 When the AUTO ON/OFF key is pressed for about 3 seconds the recorder exits
the automatic measurement mode and the " A " disappears. Conversly, by
pressing the key again the " A " will reappear.
Manual Measurement
Step 1 Press the START STOP key. The recorder starts a measurement at once. The
results are displayed and stored in memory.
To stop a Current Measurement
Step 1 Press the START STOP key during measurement. The recorder will stop the
measurement at once and releases the air from the cuff.
Automatic Measurement Operation
AUTO ON/OFF