Olympus WS-823 - Manual (Page 101)

7
Troubleshooting
101
EN
Problem Possible cause Solution
The display is blank.
The battery is not inserted
properly.
Check that the positive and negative
terminals of the battery are placed
correctly (
☞ P.9).
The remaining battery power
is low. Replace or charge the battery ( ☞ P.9,
P.11).
The power is OFF. Turn the power ON (
☞ P.9).
Unable to operate the
voice recorder
The remaining battery power
is low. Replace or charge the battery (
☞ P.9,
P.11).
The power is OFF. Turn the power ON (
☞ P.9).
The voice recorder is in HOLD
mode.
Release HOLD mode (
☞ P.19).
Unable to record
There is no remaining memory. Erase unneeded files (
☞ P.46).
The maximum number of
recordable files has been reached.
Select another folder (
☞ P.23, P.24).
WS-823 model only
[Speaker] has been selected for
[Output] in the [FM Menu].
Select [Earphone] for [Output] ( ☞ P.81).
Playback is inaudible.
The earphones are connected to
the EAR jack. To output the playback through the built-
in speaker, disconnect the earphones.
[Off] has been selected for
[Speaker].
To output the playback through the
built-in speaker, select [On] for [Speaker]
(
☞ P.76).
The volume is set to [00]. Adjust the volume (
☞ P.34).
The recording is too
quiet.
A low recording level has been
set. Redo recording after setting the recording
level to [High] or [Middle] (
☞ P.63).
The output level of the connected
external device may be too low. Adjust the output level of the external
device.
WS-823 model only
The recording level hasn’t been
adjusted. Redo recording after adjusting the
recording level (
☞ P.63).
Troubleshooting