Olympus DS-5000ID - Manual (Page 19)

19
1
Charging Battery Pack
Charging Battery Pack
Directly Charging Through the
Recorder
The Ni-MH Rechargeable Battery Pack in the
recorder can be charged by connecting an AC
adapter or USB cable to the recorder.
Charging using AC Adapter (no cradle)
Connect the AC adapter to the recorder.
For connection procedures, see P.21.
When using the adapter for charging, connect the
power plug to the recorder power jack.
Charging using the USB cable (no cradle)
While recorder’s POWER switch is turned
OFF, connect the USB cable to the recorder.
When the recorder is connected to a USB cable while
its POWER switch is turned OFF, only charging will
be performed, and the computer will not recognize it
as a drive.
Notes
• Charge the battery pack often for first few uses. Battery
pack performs better after several full charge/discharge
cycles.
• Battery packs other than the supplied battery pack
cannot be charged.
• If you charge the battery pack right after charging is
complete, it will take only few minutes to charge the
battery pack.
• The PC must be ON when charging battery pack via
the USB cable connection.
• Charging battery pack via the USB cable connection
may not be successful depending on the power supply
capacity of your PC. Use the AC adapter instead.
• Do not set or remove the recorder from the cradle while
it is in operation.
• Do not charge the recorder with the USB hub connected.
• Do not attach or remove the rechargeable battery pack
if the AC adapter or USB cable is connected.