Olympus DS-5000ID - Manual (Page 23)

23
1
Inserting and Ejecting a SD card
Inserting and Ejecting a SD card
Inserting a SD card
Insert the SD card into the card slot in the
direction shown in the illustration until it
clicks.
This recorder uses a microSD card as its built-
in memory. The microSD card has been
preloaded. Refer to P.63 when removing or
inserting the card during emergencies.
Ejecting a SD card
Push the SD card inward once to unlock it,
and let it eject.
SD Card
Selected
SD
Notes
• Insert the card keeping it straight.
• The card stops with a click when it is inserted all
the way.
• Inserting the card the wrong way or at an angle
could damage the contact area or cause the card
to jam.
• If the card is not inserted all the way, data may not
be written to the card.
• Hold the card straight and pull it out.
• If a unformatted card is installed, the recorder will
automatically display the menu format option ( ☞ P.64).
• Never use any card in the recorder unless it has been
formatted on this unit (
☞ P.64).
• Never remove the card while the recorder is in
operation. This may damage the data.
• Releasing your finger quickly after pushing the card
inward may cause it to eject forcefully out of the slot.
Recorder Card Selection
When inserting SD card into the SD card slot, the
recorder message [Please Wait] will flashes on the
LCD display for few seconds while validating the
SD card.
The recorder recording destination will be the default
location selected from the menu [Card Select] option
when available. In case the default location is not
available, the recorder will automatically change
over to the other card. When SD card selected from
the menu [Card Select] option is ejected from the
recorder, the recorder will automatically change over
the recording destination to the other card.