Pioneer AVIC-F850BT - Manual (Page 155)

Black plate (155,1)
CAUTION
! Thoroughly check the conditions before per-
forming Auto EQ, as the speakers may be da-
maged if this is performed under the following
conditions:
— When the speakers are incorrectly con-
nected. (For example, when a rear speaker
is connected as a subwoofer output.)
— When a speaker is connected to a power
amp delivering output higher than the
speaker
’s maximum input power capabil-
ity.
! If a microphone for acoustical measurement
(sold separately) is not placed in an appropri-
ate location, the measurement tone may be-
come loud and measurement may take a long
time, resulting in battery drainage. Be sure to
place the microphone in the specified loca-
tion.
Before operating the Auto EQ
function
! Perform Auto EQ in as quiet a place as pos-
sible, with the vehicle engine and air condi-
tioning switched off. Also, cut power to car
phones or mobile phones in the vehicle, or
remove them from the vehicle before per-
forming Auto EQ. Sounds other than the
measurement tone (surrounding sounds,
engine sound, telephones ringing, etc.)
may prevent correct measurement of the
vehicle
’s acoustics.
! Be sure to perform Auto EQ using the mi-
crophone for acoustical measurement
(sold separately). Using another micro-
phone may prevent measurement, or result
in incorrect measurement of the vehicle
’s
acoustics.
! To perform Auto EQ, the front speakers
must be connected.
! When this navigation system is connected
to a power amp with input level control,
Auto EQ may be impossible if the power
amp
’s input level is set below the standard
level.
! When this navigation system is connected
to a power amp with an LPF (low pass fil-
ter), turn the LPF off before performing
Auto EQ. Also, set the cut-off frequency for
the built-in LPF of an active subwoofer to
the highest frequency.
! The distance has been calculated by com-
puter to provide optimum delay to ensure
accurate results. Do not change this value.
— The reflected sound within the vehicle is
strong and delays occur.
— The LPF on active subwoofers or exter-
nal amps delay the lower sounds.
! If an error occurs during measurement, a
message appears and measurement is
cancelled. Check the following before mea-
suring the vehicle
’s acoustics.
— Front speakers (left/right)
— Rear speakers (left/right)
— Noise
— Microphone for acoustical measure-
ment (sold separately)
— Low battery
Performing Auto EQ
p Auto EQ changes the audio settings as fol-
lows:
! “Auto EQ” on the “EQ Menu” screen is
set to
“On”.
= For details, refer to Using the auto-ad-
justed equaliser on page 153.
! The fader/balance settings return to the
centre position.
= For details, refer to Using balance ad-
justment on page 150.
! The equaliser curve switches to “Flat”.
= For details, refer to Using the equali-
ser on page 151.
! The front and rear speakers will automa-
tically be adjusted to a high pass filter
setting.
p Previous settings for Auto EQ will be over-
written.
p For AVIC-F50BT users
<CRB4228-A>155
Engb
155
Chapter
26
Customising
pr
eferences
Customising preferences