Pioneer X-HM50-K - Manual (Page 17)

11/2/23 X-HM50_En.fm
17
Listening to the FM radio
Notes
• When radio interference occurs, auto scan tuning
may stop automatically at that point.
• Auto scan tuning will skip weak signal stations.
• To stop the auto tuning, press the
TUNING ( or )
button again.
• When an RDS (Radio Data System) station is tuned
in, the frequency will be displayed first, and then the
RDS indicator will light up. Finally, the station name
will appear.
To receive an FM stereo transmission:
• Press the
TUNER (BAND) button to select stereo
mode and “ ST ” indicator will be displayed. “ ” and
“ ” will appear when an FM broadcast is in stereo.
• If the FM reception is weak, press the TUNER (BAND)
button to extinguish the “ ST ” indicator. The reception
changes to monaural, and the sound becomes
clearer.
You can store 40 FM stations in memory and recall
them at the push of a button. (Preset tuning)
Note
The backup function protects the memorised stations
for a few hours should there be a power failure or the
AC power lead become disconnected.
Press the PRESET ( or ) button for less than 0.5
seconds to select the desired station.
The stations saved in the memory can be scanned
automatically. (Preset memory scan)
n Tuning
1 Press the STANDBY/ON button to turn the power on.
2 Press the TUNER (BAND) button repeatedly to
select the “FM”.
3 Press the TUNING ( or ) button on the remote
control to tune in to the desired station.
• Manual tuning:
Press the TUNING ( or ) button repeatedly
to tune in to the desired station.
• Auto tuning:
When the TUNING ( or ) button is pressed
for more than 0.5 seconds, scanning will start
automatically and the tuner will stop at the first
receivable broadcast station.
STANDBY/ON
INPUT
PHONES AUDIO IN
TIMER
VOLUME
USB
X-HM50
STANDBY/ON
INPUT
n Memorising a station
1 Perform steps 1 - 3 in “Tuning”.
2 Press the MEMORY button.
3 Within 30 seconds, press the PRESET ( or )
button to select the preset channel number.
Store the stations in memory, in order, starting with
preset channel 1.
4 Within 30 seconds, press the MEMORY button to
store that station in memory.
If the “
MEMORY ” and preset number indicators
disappear before the station is memorised, repeat
the operation from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change
a preset station.
When a new station is stored in the memory, the
station previously memorised for that preset channel
number will be erased.
n To recall a memorised station
n To scan the preset stations
1 Press the PRESET ( or ) button for more than 0.5
seconds.
The preset number will flash and the programmed
stations will be tuned in sequentially, for 5 seconds
each.
2 Press the PRESET ( or ) button again when the
desired station is located.
n To erase entire preset memory
1 Press the STANDBY/ON button to enter the stand-
by mode.
2 Whilst pressing down the button, press the
STANDBY/ON button until “Tuner Clear” appears.
STANDBY/ON