Pioneer X-HM50-K - Manual (Page 24)

11/2/23 X-HM50_En.fm
24
Enhancing your system
The connection lead is not included. Purchase a
commercially available lead as shown below.
Note
To prevent noise interference, place the unit away from
the television.
• Do not turn the volume on to full at switch on and
listen to music at moderate levels. Excessive sound
pressure from earphones and headphones can
cause hearing loss.
• Before plugging in or unplugging the headphone,
reduce the volume.
• Be sure your headphone has a 3.5 mm diameter
plug and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.
• Plugging in the headphone disconnects the
speakers automatically. Adjust the volume using the
VOLUME control.
• Audio from the iPod/iPhone cannot be heard via the
headphones connected to the unit. “ Not Support
HP ” will be displayed if you connect the headphones
when the iPod/iPhone function is selected.
Troubleshooting chart
Many potential problems can be resolved by the owner
without calling a service technician.
If something is wrong with this product, check the
following before calling your authorized PIONEER
dealer or service centre.
n Listening to the playback sounds of
portable audio player, etc.
1 Use a connection lead to connect the portable
audio player etc. to the AUDIO IN socket.
When using video equipment, connect the audio
output to this unit and the video output to a
television.
2 Press the STANDBY/ON button to turn the power on.
3 Press the AUDIO/LINE (INPUT) button on the
remote control or INPUT button repeatedly on main
unit to select AUDIO IN function.
4 Play the connected equipment.
If volume level of the connected device is too high,
sound distortion may occur. Should this happen,
lower the volume of the connected device. If volume
level is too low, increase the volume of the connected
device.
n Headphones
STANDBY/ON
INPUT
PHONES AUDIO IN
TIMER
VOLUME
USB
X-HM50
PHONES AUDIO IN USB
Audio cable (not supplied)
Portable audio
player, etc.
n General
Symptom Possible cause
• The clock is not set
to the correct time.
• Did a power failure
occur?
• Reset the clock. (Refer
page 9)
• When a button is
pressed, the unit
does not respond.
• Set the unit to the power
stand-by mode and then
turn it back on.
• If the unit still
malfunctions, reset it.
(Refer page 24)
• No sound is heard. • Is the volume level set to
“Min”?
• Are the headphones
connected?
• Are the speaker wires
disconnected?
n CD player
Symptom Possible cause
• Playback does not
start.
• Playback stops in
the middle or is not
performed properly.
• Is the disc loaded upside
down?
• Does the disc satisfy the
standards?
• Is the disc distorted or
scratched?
• Playback sounds
are skipped, or
stopped in the
middle of a track.
• Is the unit located near
excessive vibrations?
• Is the disc very dirty?
• Has condensation
formed inside the unit?
n Remote control
Symptom Possible cause
• The remote control
does not operate.
• Is the AC power lead of
the unit plugged in?
• Is the battery polarity
correct?
• Are the batteries dead?
• Is the distance or angle
incorrect?
• Does the remote control
sensor receive strong
light?