Troubleshooting 166, Problems in the screen 166, Troubleshooting – Pioneer AVIC-HD3 RU User Manual

Page 168: Problems in the screen

Advertising
background image

166

Ap

pe

nd

ix

NAVI

/A

V

Troubleshooting

If you have problems operating your navigation system, refer to this section. The most common prob-
lems are listed below, along with likely causes and solutions. While this list is not comprehensive, it
should answer your most common problems. If a solution to your problem cannot be found here, con-
tact your dealer or the nearest authorised Pioneer service facility.

Problems in the screen

Symptom

Cause

Action (See)

Power doesn’t turn on. The naviga-

tion system doesn’t operate.

Leads and connectors are incorrectly

connected.

Confirm once more that all connec-

tions are correct.

The fuse is blown.

Rectify the reason for the fuse blow-

ing, then replace the fuse. Be very

sure to install a correct fuse with the

same rate.

Noise and other factors are causing

the internal memory to operate incor-

rectly.

Refer to “Returning the Navigation

System to the Default or Factory Set-

tings” and carry out appropriate

measures. (➞ Page 157)

The hard disk drive is not working

because the temperature is

extremely low or high.

Wait until the temperature inside the

vehicle falls or rises.

When the ignition switch is turned

ON (or turned to ACC), the motor

sounds.

This system confirms whether a disc

is loaded or not.

This is a normal operation.

The navigation does not boot up.

The power cable is not wired cor-

rectly.

Turn the system off and the check

the wiring.

The hard disk drive is not running

because the temperature is too low.

Wait until the inside of the vehicle

warms up.

The hard disk drive is defective.

Consult your authorised Pioneer

dealer.

You cannot position your vehicle on

the map or the positioning error is

large.

The quality of signals from the GPS

satellites is poor, causing reduced

positioning accuracy. Such a loss of

signal quality may happen for the fol-

lowing reasons:

• The GPS aerial is in an unsuitable

location.

• Obstacles are blocking signals

from the satellites.

• The position of satellites relative to

your vehicle is bad.

• Signals from the GPS satellites

have been modified to reduce

accuracy. (GPS satellites are oper-

ated by the US Department of

Defense, and the US government

reserves the right to distort posi-

tioning data for military reasons.

This may lead to greater position-

ing errors.)

• If a vehicle phone or mobile phone

is used near the GPS aerial, GPS

reception may be lost temporarily.

• Do not cover the GPS aerial with

spray paint or vehicle wax, because

this may block the reception of

GPS signals. Snow buildup can

also degrade the signals.

Check the GPS signal reception (➞

Page 81) and the position of the GPS

aerial if necessary, or continue driv-

ing until reception improves. Keep

the aerial clear.

Advertising
This manual is related to the following products: