Pioneer AVIC-HD3 RU - Manual (Page 173)

171
Ap
pe
nd
ix
NA
VI/
A
V
Messages and How to React to Them
Messages for navigation functions
The following messages may be displayed by your navigation system.
❒ There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Message When What to do
Irregular speed pulse signal
detected. Please power off the sys-
tem and check the installation. Then,
please re-boot the system and press
“OK”.
If the navigation system does not
receive the vehicle speed pulse.
Consult your Pioneer dealer.
Speed pulse not connected. Calibra-
tion will start without speed pulse.
Accuracy is not fully ensured without
speed pulse.
The speed signal input (pink lead
wire) of the power cable is not con-
nected.
To operate with 3D hybrid mode, con-
nect the speed signal input (pink
lead wire) of the power cable cor-
rectly.
Although it can be operated with
Simple hybrid mode without con-
necting the speed signal input, the
precision of the positioning will be
less accurate.
Vibration detected. Please power off
the system and check the installa-
tion. Then, please re-boot the system
and press “OK”.
The navigation unit is installed in a
place where it may be affected by a
large vibration.
Re-install the navigation unit in a
place where the unit will not be
affected by vibration.
Direction of G sensor is not correct.
Please power off the system and
check the installation. Then, please
re-boot the system and press “OK”.
Direction of G sensor is set incor-
rectly.
See the Installation Manual and set
the direction of the navigation unit
correctly.
Gyro Sensor is not working properly.
Please consult your dealer or Pioneer
service centre.
Abnormal output of Gyrosensor is
detected.
Note down the error code shown on
the screen; turn off the power, and
then contact your nearest Pioneer
service facility.
Positioning is not possible due to the
hardware. Please contact your dealer
or Pioneer service centre.
The location display is not possible
due to failure of hardware.
Consult your dealer.
GPS antenna problem detected.
Please contact your dealer or Pioneer
service centre.
The location display is not possible
due to failure of GPS aerial.
Consult your dealer.
This function is currently unavailable. The screen cannot be displayed with
Vehicle Dynamics Display.
The sensor has not been taught so
the sensor information cannot be
acquired.
If the sensor learning status reaches
the Sensor Initialising status, the sys-
tem is ready to be used.
The vertical installation angle is
changed. Gyro Sensor calibration is
re-initialized.
If the mounting angle of the naviga-
tion unit has been changed.
The system initialises the sensor in
order to operate it with the maximum
performance and automatically
starts re-learning.
Excess vertical installation angle
detected. Please install the naviga-
tion unit correctly.
The navigation system is installed
with an extreme angle exceeding the
limitation of the installation angle.
Confirm the installation angle. (The
navigation system must be installed
within the allowed installation angle.
For details, refer to Installation Man-
ual.)
Route calculation was not possible. Route calculation has failed because
of malfunction of map data, software,
hardware.
• Change the destination.
• Consult the Pioneer Local dealer if
this message persists.
Route calculation not possible
because destination is too far.
If the destination is too far. • Set a destination closer to the start-
ing point.
• Set one or more waypoints.