Pioneer AVIC-HD3 RU - Manual (Page 84)

82
Chapter
8
Mod
if
ying
the Genera
l Sett
in
g
s
for Navi
g
at
ion Fu
nctions
NAV
I
(4) Installation Position
The installation position of the navigation sys-
tem is shown. That indicates whether the
installation position of the navigation system
is correct or not. If installed correctly, [OK]
appears. When the navigation system is
installed at an extreme angle exceeding the
limitation of the installing angle, [Incorrect
angle] will be displayed. When the angle of
the navigation system has been changed,
[Excessive vibration] will be displayed.
(5) Handbrake
When the handbrake is applied, [On] is dis-
played. When the handbrake is released, [Off]
is displayed.
(6) Power Voltage
The power voltage (reference value) provided
from the vehicle battery to the navigation sys-
tem is shown. If the voltage goes out of the
range from 11 to 15 V, check that power cable
connection is correct.
(7) Illumination
When the headlights or small lamps of a vehi-
cle are on, [On] is displayed. When the small
lamps of a vehicle are off, [Off] is displayed. (If
the orange/white lead is not connected, [Off]
appears.)
(8) Back Signal
When the gear lever is shifted to “R”, the sig-
nal switches to [High] or [Low]. (Either of
these is displayed depending on the vehicle.) Checking sensor learning status
and driving status
1
Touch [Settings] in the navigation menu,
then touch [Hardware].
2
Touch [3D Calibration Status].
The 3D Calibration Status screen appears.
(1) Distance
Driving distance is indicated.
(2) Speed Pulse
Total number of speed pulses is indicated.
(3) Learning Status
Current driving mode is indicated.
(4) Degree of learning
Sensor learning situations of distance
(Distance), right turn (Right Turn), left turn
(Left Turn), and 3D detection (3D Detection)
are indicated by the length of bars.
❒ When tyres have been changed or chains
fitted, turning on the Speed Pluse allows
the system detects the fact that the tyre
diameter has changed, and automatically
replaces the value for calculating distance.
❒ If the ND-PG1 is connected, the distance
calculation value cannot be replaced auto-
matically.
(5) Speed
The speed detected by the navigation system
is indicated. (This indication may be different
from the actual speed of your vehicle, so
please do not use this instead of the speedom-
eter of your vehicle.)
(6) Acceleration or deceleration/Rota-
tional speed
Acceleration or deceleration velocity of your
vehicle is indicated. Also, rotational speed
when your vehicle turns to left or right is
shown.
(7) Inclination
Degree of slope for the street is indicated.
(4)
(1)
(2)
(3)
(5)
(6)
(7)