Pioneer SC-LX90 - Manual (Page 120)

Additional information 13
120
En
HDMI
Symptom Remedy
The HDMI indicator blinks
continuously. • Check all the points below.
No picture or sound. • This amplifier is HDCP-compatible. Check that the components you are connecting are also HDCP-
compatible. If they are not, please connect them using the component, S-Video or composite video jacks.
• Depending on the connected source component, it’s possible that it will not work with this amplifier (even
if it is HDCP-compatible). In this case, connect using the component, S-Video or composite video jacks
between source and amplifier.
• If the problem still persists when connecting your HDMI component directly to your monitor, please
consult the component or monitor manual or contact the manufacturer for support.
• If video images do not appear on your TV or plasma television, try adjusting the resolution, DeepColor or
other setting for your component.
• If ‘
NOT SUPPORT’ appears in the amplifier’s display, try adjusting the resolution, DeepColor or other
setting for your component.
• While analog video signals are being output over HDMI, use a separate connection for audio output.
• When this amplifier reproduces MULTI CH IN audio sources with the HDMI setting set to THROUGH, you
cannot hear audio output from all channels. In this case, make a digital or analog audio connection.
• To output signals in DeepColor, use an HDMI cable (High Speed HDMI™ Cable) to connect this amplifier
to a component or TV with the DeepColor feature.
No picture. • Try changing the Resolution setting (in Setting the Video options on page 101).
• Set the HDMI output setting to the connected HDMI OUT terminal (in Switching the HDMI output on
page 103).
No sound, or sound suddenly
ceases. • Check that the HDMI AV setting is set to AMP/THROUGH.
• If the component is a DVI device, use a separate connection for the audio.
• If analog video is being output over HDMI, please use a separate connection for the audio.
• Check the audio output settings of the source component.
Noisy or distorted picture. • Sometimes a video deck may output a noisy video signal (during scanning, for example), or the video
quality may just be poor (with some video game units, for example). The picture quality may also depend on
the settings, etc. of your display device. Switch off the video converter and reconnect the source and display
device using the same type of connection (component, S-Video or composite), then start playback again.
• If the problem still persists when connecting your HDMI component directly to your monitor, please
consult the component or monitor manual or contact the manufacturer for support.
HDCP ERROR shows in the
display. • Check whether or not the connected component is compatible with HDCP. If it is not compatible with
HDCP, reconnect the source device using a different type of connection (component, S-Video or
composite). Some components that are compatible with HDCP still cause this message to be displayed, but
so long as there is no problem with displaying video, this is not a malfunction.
Amp-linked operation not
possible using HDMI control
function. • Select ON for the HDMI control setting (see Setting the HDMI Control mode on page 92).
• Turn the TV’s power on before turning on this amplifier’s power.
• Set the TV side HDMI control setting to
ON.
• Connect the TV to the HDMI OUT 1 terminal and set the HDMI output to HDMI OUT 1. Then turn on first
the TV’s power, then this amplifier’s power.
SC_LX90_WY.book Page 120 Wednesday, February 6, 2008 11:49 AM