Pioneer SC-LX90 - Manual (Page 70)

Other connections 07
70
En
Use a commercially-available cable to connect the
RS-232C jack on your computer to the 9-pin RS-232C jack
on this amplifier. See the documentation provided with
the Advanced MCACC application for more information.
Advanced MCACC output using your PC
Before continuing, make sure you have completed step 1
in
Data Management on page 50. Note that transmission
data is erased when the amplifier is turned off.
1 Select ‘Output PC’ and press ENTER.
When the amplifier is ready for transmission, Start the
MCACC application on your PC shows on the OSD.
2 Start the MCACC application on your computer.
Follow the instructions provided with the application. It
will take about ten seconds for the transmission to
complete, then you will be able to analyze the output on
your computer. Since the data will be cleared from the
amplifier when you restart reverb measurement or turn
off the amplifier, you might want to save the information
on your PC after measurement.
3 When you’re finished, press RETURN.
You will return to the Data Management menu. Continue
with other settings in the Data Management menu if
necessary. Press
RETURN again to exit the Data
Management menu.
RS-232C
Personal computer
: R e t u r n
5 . D a t a M a n ag e m e n t
DV D / L D - 5 5 . 0 dB
a . M C AC C D a t a C h e ck
b . M e m o r y R e n a m e
c . M C AC C M e m o r y C o py
d . M C AC C M e m o r y C l e a r
e . O u t p u t P C
S t a r t t h e M C A C C
a p p l i c a t i o n o n y o u r P C .
: C a n c e l
5 e . O u t p u t P C
DV D / L D - 5 5 . 0 dB
SC_LX90_WY.book Page 70 Wednesday, February 6, 2008 11:49 AM