Pioneer SC-LX90 - Manual (Page 17)

Connecting your equipment 03
17
En
9 Multichannel analog audio inputs
7.1 channel inputs for connection to a DVD player with
multichannel analog outputs.
 See Connecting the multichannel analog inputs on
page 60.
10 Stereo analog audio source inputs/(outputs) (x5)
Use for connection to audio sources such as CD players,
tape decks, turntables, etc.
 See Connecting analog audio sources on page 26.
11 Audio/video source inputs/(outputs) (x7)
Use for connection to audio/visual sources, such as DVD
players/recorders, VCRs, etc. Each set of inputs has jacks
for composite video, S-Video 1 and stereo analog audio.
 See Connecting a DVD/HDD recorder, VCR and other
video sources on page 23.
12 Composite, S-Video and Component monitor
outputs
Use to connect monitors and TVs.
 See Connecting your TV and DVD player on page 20.
 See Using the component video jacks on page 24.
13 MULTI-ZONE video outputs
Use to connect monitors or TVs in a separate room.
 See MULTI-ZONE listening on page 64.
14 12 V trigger jacks (total 50 mA max.) (x4)
Use to switch components in your system on and off
according to the input function of the amplifier.
 See Switching components on and off using the 12
volt trigger on page 67.
15 Component video inputs (x5)
Use the inputs to connect any video source that has
component video output, such as a DVD recorder.
 See Using the component video jacks on page 24.
16 MULTI-ZONE component video output
Use to connect monitors or TVs in a separate room.
 See MULTI-ZONE listening on page 64.
17 Control input/output
Use to connect other Pioneer components so that you
can control all your equipment from a single IR remote
sensor.
 See Operating other Pioneer components with this
unit’s sensor on page 111.
18 RS-232C connector
Use for connection to a PC for graphical output when
using Advanced MCACC or Full Band Phase Control.
 See Connecting a PC for Advanced MCACC output on
page 69.
19 Remote inputs/outputs (MULTI-ZONE and source)
Use for connection to an external remote control sensor
for use in a MULTI-ZONE setup, for example.
 See Connecting an IR receiver on page 67.
20 Speaker terminals
Use for connection to the main front, center, surround
and surround back speakers.
 See Installing your speaker system on page 27.
21 AC power inlet
Connect the supplied power cord here.
When making cable connections
• To avoid hum, do not lay connected cables over the
top of the amplifier.
• When connecting optical cables, be careful when
inserting the plug not to damage the shutter
protecting the optical socket.
• When storing optical cable, coil loosely. The cable
may be damaged if bent around sharp corners.
Note
1 You must assign the input source to the S-Video input to which you’ve connected your video component (see The Input Setup menu on page 94).
SC_LX90_WY.book Page 17 Wednesday, February 6, 2008 11:49 AM