Pioneer VSX-818V-K - Manual (Page 52)

Controlling the rest of your system 09
52
En
Selecting preset codes directly
1 While pressing the RECEIVER button,
press and hold the ‘ 1 ’ button.
The LED blinks.
2 Press the MULTI CONTROL button for the
component you want to control.
The LED lights on continuously.
3 Use the number buttons to enter the
preset code.
You can find the preset codes on page 56.
The LED blinks again after you enter the code.
If the correct code has been input the power of
the component being input will turn on or off.
The power of the component being input will
only turn on or off if that component is able to
be turned on directly by remote control.
• You can only input a code for the component
type written on each MULTI CONTROL
button.
1
• Even if you don’t input a preset code for the
TV ( TV MULTI CONTROL button) you will
be able to control your TV using the
dedicated
TV CONTROL on the remote if
you have assigned it to the TV CTRL button.
4 Repeat steps 2 through 3 to try a different
code, or to enter a code for another
component you want to control.
5 When you’re done, press RECEIVER .
Direct function
• Default setting: ON
You can use the direct function feature to
control one component using the remote
control while at the same time, using your
receiver to playback a different component.
This could let you, for example, use the remote
control to set up and listen to a CD on the
receiver and then use the remote control to
rewind a tape in your VCR while you continue
to listen to your CD player.
When direct function is on, any component
you select (using the
MULTI CONTROL
buttons) will be selected by both the receiver
and the remote control. When you turn direct
function off, you can operate the remote
control without affecting the receiver.
2
1 While pressing the RECEIVER button,
press and hold the ‘4’ button.
The LED blinks.
2 Press the MULTI CONTROL button for
the component you want to control.
The LED lights on continuously.
3 Use the number buttons to enter either
‘1’ (direct on) or ‘2’ (direct off).
The LED blinks again.
4 Repeat steps 2 through 3 for the other
components you want to control.
5 When you’re done, press RECEIVER .
Clearing all the remote control
settings
You can clear all presets and restore the
factory default settings.
• While pressing the RECEIVER button,
press and hold the ‘0’ button for three
seconds.
The LED blinks three times indicating the settings
have been restored to the factory presets.
Note
1 • TV codes (for example, codes for TV, CATV, Satellite TV or DTV) can only be assigned to the TV or TV CTRL button.
• You can’t assign the FM / AM or RECEIVER buttons.
RECEIVER
INPUT SELECT
TV CTRL
SOURCE
TV DVR
AM FM
CD-R
CD
PORTABLE
iPod USB DVD
RECEIVER
MULTI CONTROL
TV CONTROL
MPX
DIMMER SLEEP
D.ACCESS
SIGNAL SEL
TUNER DISP CLASS
DISC
B C D E
SR + iPod CTRL
ENTER
INFO
MIDNIGHT ANALOG ATT
+ 10
EON
2 You can’t use direct function with the FM / AM and TV CTRL functions.
VSX_918_818_MY.book 52 ページ ２００７年１２月２７日 木曜日 午後４時２７分