Using sonic centre control 147, Adjusting loudness 147, Using subwoofer output 147 – Pioneer AVIC-F930BT User Manual
Page 147: Customising preferences, Using sonic centre control, Adjusting loudness, Using subwoofer output
9
Exit the vehicle and keep the door
closed until the countdown finishes.
When the countdown is over, a measurement
tone (noise) is emitted from the speakers and
the Auto EQ measurement begins.
10 Wait until the measurement is com-
pleted.
When Auto EQ is completed, a message is dis-
played indicating that the measurement is
completed.
p If the vehicle’s acoustics cannot be mea-
sured correctly, an error message will be
displayed.
p The measurement time varies depending
on the type of vehicle.
p To stop the measurement, touch [Stop].
11 Touch [OK].
12 Store the microphone carefully in the
glove compartment or another safe place.
If the microphone is subjected to direct sun-
light for an extended period of time, high tem-
peratures may cause distortion, colour change
or malfunction.
Using sonic centre control
Sound that is suited for the listening position
can easily be created with this function.
1
Display the
“AV Sound Settings”
screen.
= For details, refer to Displaying the screen for
AV sound settings on page 142.
2
Touch [Sonic Center Control].
3
Touch [c] or [d] to select a listening po-
sition.
p The larger the value of the range: “Left7” to
“Right7” setting, the greater the delay of
the speaker output.
p When “Left” is set, the left speaker output
is delayed. When
“Right” is set, the right
speaker output is delayed.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1
Display the
“AV Sound Settings”
screen.
= For details, refer to Displaying the screen for
AV sound settings on page 142.
2
Touch [Loudness].
Each time you touch [
Loudness], the level is
selected in the following order:
Off
— Low — Mid — High
Using subwoofer output
The navigation system is equipped with a sub-
woofer output mechanism, which can be
turned on or off.
p This function is not available when “Sub
Woofer
” is “Off”.
1
Display the
“AV Sound Settings”
screen.
= For details, refer to Displaying the screen for
AV sound settings on page 142.
2
Touch [Sub Woofer].
3
Touch [On].
The subwoofer output is turned on.
# If you touch [Off], the subwoofer output is
turned off.
4
Touch [Reverse] or [Normal] to select
the phase of subwoofer output.
Engb
147
Chapter
26
Customising
pr
eferences
Customising preferences