Pioneer KRP-600A - Manual (Page 16)

Preparation 05
16
En
Moving the display
When installing on a rack, etc., hold the display as shown below.
Because the display is heavy, be sure to have someone help you
when moving it.
Note
• Do not use the speaker to support the weight of the display.
• Do not hold the display by the speaker mounting fittings.
Preventing the display from falling
over
After installing the stand, be sure to take special care to ensure that
the display will not fall over and is stabilized to both the wall and
rack.
Stabilizing on a table or rack
Stabilize the display as shown in the diagram using the falling
prevention metal fittings and screws supplied with the optional
stand.
Note
• Before stabilizing the display on a stand or rack, make sure that
the falling prevention metal fittings are attached to the stand.
• To stabilize the display on a table or rack, also use commercially
available wood screws that have a nominal diameter of 4 mm
and that are at least 20 mm long.
Drill a hole in the middle at the rear of the tabletop panel before
using a wood screw. Perform this work the same way on the left and
right sides.
Drill a hole in the middle at the rear of the tabletop panel before
using a wood screw. Perform this work the same way on the left and
right sides.
(KRP-600P)
(KRP-500P)
(KRP-600P)
8
mm to 15
mm
20 mm min.
4 mm
Wood screw
(commercially available,
4 mm x 20 mm min.) Falling prevention
metal fitting
(KRP-500P)
Wood screw
(commercially available,
4 mm x 20 mm min.)
Falling prevention
metal fitting
8 mm to 1
5 mm
20 mm min.
4 m
m
KRP-600A_500A.book Page 16 Monday, September 8, 2008 10:31 AM